The Original Water Alarm - Senses high water levels in sump pumps, basements, and other places where water damage occurs

Product Catalog:

Customer Account:

It’s easier to protect your home from water damage than to pay for water damage repair, and the original Water Alarm is an easy, affordable solution. Though it may look a little strange, the design of the original Water Alarm allows it to be the most moisture-sensitive, compact and indestructible alarm on the market. Its unique bell tower amplifies the alarm so it can sound longer and louder than any other alarm. The four stainless steel legs can detect moisture at the first sign of leakage--well before damage can occur. They sink deep into carpet, fabric or other materials that would take up to an inch of water above the carpet to set off other alarms. Don't risk the preservation of your home to inferior alarms, trust the original Water Alarm.

Buy 3 pay just 27.95 each. Buy 5 or more and pay just 25.95 each!

This attachment acts as a sump pump overflow warning, bathtub full alert, and hot tub full alert. You can easily attach it to the bottom of the Water Alarm by gently sliding the open end of each connector on the bottom of the Water Alarm. It has a 1 year warranty. For use with the Original Water Alarm only.

How the Washing Machine Leak Alarm Works:
Simply connect the FloodStop valve onto the hot and cold water hose bibs, and place the water/leak sensor at the base of the washing machine. When the sensor detects water, the FloodStop valve automatically closes and sounds an alarm. The valve stays closed until problem is attended to and system is reset.

How FloodStop (FS 3/4-NPT) Works:
Simply connect the FloodStop valve between the Water Heater and manual shutoff valve, and place the water/leak sensor at the base of the water heater. When the sensor detects water, the FloodStop valve automatically closes and sounds an alarm. The valve stays closed until problem is attended to and system is reset.

Use this item for any 3/4" NPT application. Not just limited to Water Heaters!

1 1/4" Pipe Threaded – Full-Port Motorized Ball Valve (Brass)

NEW MODEL! Has backup battery (standard C batteries) source and output contacts for connection to Alarm or Home Automation/Monitoring systems if desired, to automatically alert the property owner if the systems was activated!

[1 1/4" NPT threaded fitting.] Prevent Water Heaters from flooding your property, water heaters will eventually leak after years of corrosion. Though they are generally considered maintenance-free appliances, the small pressurized leaks can quickly flood and devastate a home. The FloodStop for Water Heaters automatically shuts off the water supply to the Water Heater and sounds an alarm, leaving all other household fixtures and appliances operational. It is easily installed in fifteen minutes.

How FloodStop (FS 3/4-NPT) Works:
Simply connect the FloodStop valve between the Water Heater and manual shutoff valve, and place the water/leak sensor at the base of the washing machine. When the sensor detects water, the FloodStop valve automatically closes and sounds an alarm. The valve stays closed until problem is attended to and system is reset.

Use this item for any 1 1/4" NPT application. Not just limited to Water Heaters and Water Softeners. The Water main is a great location for this item.

3/8” Compression – Motorized Ball Valve (Brass/Chrome Finish)

NEW MODEL! Dishwasher leaks are often small and go unnoticed until significant damage is finally discovered. Such a leak will continue to collect under the Dishwasher and then seep between the kitchen flooring and sub-flooring. The damage often goes undetected until the floor is visually buckled or warped, at which time the damage and cost to replace is extensive.

Toilet overflows can be the cause of significant property damage. The actual overflow event typically takes a couple minutes to begin and often goes unnoticed long after the occupant has left the bathroom.

How Floodstop (FS 3/8-C2) Works:

Automatically shuts off the water supply to the Dishwasher or Toilet, whether caused by a small continuous leak, broken component, leaking seal, overflow or a ruptured supply line. Powered by AC Adaptor/Transformer or Batteries. Output contacts available, which allow the Controller to connect with Alarm, Home Automation or Auto-Dialer systems if desired. Easily installed in ten minutes. One YearManufacturer's Warranty.

Use this item for any 3/8" Compression application. Not just limited to Dishwashers, Water Filters, and Toilets.

Prevent Sink related water damage from leaking/ruptured supply lines or overflows:
Sink related leaks are often small and go unnoticed until significant damage is finally discovered. Such a leak will continue to collect under the Sink and then seep between the flooring and sub-flooring. The damage often goes undetected until the floor is visually damp or the smell of mildew is present, at which time the damage and cost to replace is extensive.

How the Floodstop Sink/Basin leak detection systems works:

The FloodStop (FS 3/8-CD) automatically shuts off the water supply to the Sink, whether caused by a ruptured supply line, leaking garbage disposal or an overflow. Powered by AC Adaptor/Transformer or Batteries. Output contacts available, which allow the Controller to connect with Alarm, Home Automation or Auto-Dialer systems if desired. Easily installed in ten minutes. One YearManufacturer's Warranty.

1/4" Compression – Motorized Ball Valve (Brass/Chrome Finish)

NEW MODEL! Water Filter and Icemaker components are small and break easily. Water-line breaks develop from movement, accidental bumping and simple vibration. In many cases a crack in the water-line grows from simple vibrations, eventually and unexpectedly rupturing, and then flooding the property. Whether at home, at work, or on vacation these flooding events can go undetected for hours or even days.

How Floodstop (FS 1/4-C) Works:

Automatically shuts off the water supply to the Icemaker or Water Filter and sounds an alarm, leaving all other household fixtures and appliances operational. Easily installed in ten minutes. One YearManufacturer's Warranty.

Use this item for any 1/4" Compression application. Not just limited to Water Filters and Ice Makers.

Extra Floodstop water detection sensor pad to protect more than one area at the same time or to "daisy chain" to extend your reach. Comes with 3' of wire. For use with Floodstop products only.

Provides additional detection/floor coverage if desired. One or more “Extra Sensors” can be plugged into one another in series (additional sensors come with a 1 meter wire).